Hygienic 2

Gather all components needed to assemble the Hygienic 2.

Click here to see an exploded view and parts list of the Hygienic 2.

Install Bushings 75-1846 into Geared Nozzle Carrier 75-1851S.

Install Retaining Rings 75-1847 into Geared Nozzle Carrier 75-1851S (above Bushings 75-1846).

Slide Horizontal Shaft 75-1844S through Nozzle Carrier Assembly.

Use 5/32" Hex Bit to Finger tighten Horizontal Shaft 75-1844S to Elbow 75-1859S.

Apply anti-seize to threads.

Place Elbow 75-1859S in a soft jawed vice and torque Horizontal Shaft 75-1844S to 20 in-lbs.

Install Roll Pin 75-1856 into one of the holes at lower end of Body 75-1853S.

Install Bevel Gear 75-1852 to Roll Pin on body by aligning holes.

Install Retaining Ring 75-1855 to groove on Body located just above Bevel Gear 75-1852.

Install G Washer 75-1863 and Bushing 75-1408 to Vertical Shaft 75-1854.

Seat Vertical Shaft assembly onto Body 75-1853S.

Apply anti-seize to thread of Elbow 75-1859S.

Use the 1-1/8" deep socket, to Install Vertical Shaft 75-1854 to Elbow 75-1859S. Torque to 20 ft-lbs.

Install Rotor 75-1801-SS to Vertical Shaft 75-1854 using a flat wrench.

Apply anti-seize to rotor.

Tighten snugly.

Seat motor 75-1857 inside body.

Install the o-ring onto the 75-1403S Inlet Cap

Install the Inlet Cap to the 75-1853S Body.

Apply anti-seize to OD thread of inlet cap.

Use Molykote 111 or equivalent product to lubricate the O-ring.

Clamp onto flats of Body 75-1853S and tighten Inlet Cap 75-1403S to 60 ft-lbs.

Do not use excessive force when clamping.

Install Nozzles 75-1849 nozzles and tighten to 15 ft lbs.

The Hygienic 2 is complete.