3" Troll Ball

Gather all parts for your specific configuration of 3" Troll Ball. Reference the Troll Ball Parts List or click here.

Install Drive Arm 75-1436 on Vertical Shaft 75-1606 using (2) 2-60-1 Screws.

Install PTFE Washer 75-1609 and PTFE Bushing 75-1608 over Vertical Shaft 75-1606 .

The collar of the bushing should be against the washer.

Install Bottom Cap 75-1604 onto Body 75-1601.

Body 75-1601 is symmetrical. Install Bottom Cap 75-1604 with lettering or logo up.

Apply anti-seize to all threads.

Install Vertical Shaft 75-1606 Assembly to Bottom Cap 75-1601.

Install PTFE Rotor Disk 75-1628 to Motor 75-1605.

Install Motor 75-1605 assembly through the center hole of Bottom Cap 75-1601.

Install Inlet cap 75-1603 to Body 75-1601.

Apply anti-seize to all threads.

Use 1/2" Drive 1-3/4" Open End Crowfoot Wrench to tighten Bottom Cap Bottom Cap 75-1601. to 60 Ft-lbs.

This will also tighten the bottom cap and inlet cap to the body.

Install 3" Ball to Vertical Shaft 75-1606.

Secure 3" Ball with Spring Pin.